Glo-Protect Epoxy 1403 HB
Glo-Protek Epoxy 1403 is a high solids, high Build anticorrosive Epoxy Coating. It offers high degree of weather resistance to withstand sea water, fresh water, various solvents, chemicals and major environmental condition
Typical Use
As a high performance anticorrosive in ballast tanks, underwater hull, cofferdams and void spaces.
PRODUCT Data
| Mixing Ratio | 10 : 1 by volume |
|---|---|
| Pot Life | 3 Hrs (30º C) |
| Application | Airless Spray, Brush |
| Volume Solids | Approx. 68% |
| Recommended DFT/COAT | 100-150 Microns |
| Theoritical Spreading Rate | |
| At Above DFT | 7.00 - 4.67 M2 /Ltr at above DFT |
| Touch Dry | 3-3.5 hours at 30º C |
| Hard Dry | 16 Hrs. |
| Fully Cured | 7 days at 30º C |
| Over Coating Interval | Min: 6 Hrs. Max 28 days. |
| Colour | Gray – Medium to light colour |
| Finish | Satin-Sheen |
| Flash Point | Above 28º C |
| Thinner | Epoxy Thinner |
| Packing | 10 + 1 = 11 Ltr Drum |
Surface Preparation
The substrate surface/previous coat should be dry and free from all surface contaminations. The indicated maximum recoating interval refers to over-coating with itself. However, if applied over old painted surface, then the substrate surface should be roughened sufficiently before applying the coat.
METHOD OF APPLICATION
By Airless Spray, Brush
Application Method
Apply Glo-Protek AQUAGLOW with a brush, a roller, by dip method or simply by spraying on. Apply two coats of Glo-Protek AQUAGLOW to get minimum DFT of 50/60 micron.
OVER/RE-COATING INTERVAL : Min.: 6 Hrs (depends on various applications)
STORAGE
Store in sealed containers under cool and dry conditions. Store in accordance with local regulations
Safety Information
As a general rule, avoid inhalation of solvent vapour or paint mist and contact of paint with skin and eyes. Provide forced ventilation when working with solvent born coating in confined spaces or stagnant air. Skin and eye protection follow the local and international regulations